AL6063 High Power SMD3030 CL68 Series LED Ceiling light

2.1   Light source

      High Power SMD3030 LED. Low thermal resistance，pure color with consistent color  temperature，High lighting efficiency,

2.2、 Radiator

With AL6063High thermal conductivity aluminum,thermal conductivity >200W/m.k;

2.3、Shell

Shell material is AL1070 pure aluminum with high precision lathe processing，sand blasting,surface drawing,high polished,anodizing for your choose;

2.3、Light distribution

Lens with professional engineer design, material by high transmission PMMA，exact small angle of light and uniformity are important in accent lighting effect，surface of lens with quadrille and glass bead design make light be soft ，induce halation and glare;

2.3、Power supply

The external power supply，isolated with lamps ， improve lifespan of power supply and lamps，constant current drive ，Current range of small, high conversion efficiency，luminous efficiency is much better ;

Installation

4.1 According to the shown below，open one suitable mounting holes on ceiling，ensure that the minimum space is enough and don't affect the house beam, the safety of pipes and cables and other facilities ;

4.2 Make constant current source's negative and anode output lines corresponding to the LED lamp's negative and anode input lines，input parts connect high voltage（as shown in the figure）

4.3 Put the constant current source in the mounting holes，Pinch two side of the spring, upward pressure, install the lamp body into the hole，make sure installation is OK;

4.4 Ensure that the above steps after the installation，Turn The Power Switch, then lamp works;

Notice

5.1 Warning：Please do not optional retrofit lamps and lanterns, to exchange parts, lest cause an electric shock, fire and other accidents;

5.2 Lamps with constant current external power supply；Input voltage parts connect 220V directly;

5.3 After the maintenance, installation, and replace the light source，make sure installation is right, then turn on the light ;

5.4 The lamp use cannot violate any fire prevention regulations，Lights illuminate the surface must be at least 100 mm from the front lamp ;

5.5 Don't installation lamps in wet leaky environment ;

5.6 Prohibit cover lamps with insulation mat or similar material ;

5.7 Don't make paint on the surface of lamp ;

5.8 When lamps with An Exception Occurs，cut off power And ask professionals to check or contact with the local dealers ;